![]() ![]() ![]() This can solve the incompatibility problem caused by different versions of library files with the same name. When you use other devices, please remove the library files in the seeed folder and keep the compiler calling only one library file. If you use a seeed-SAMD device, please select and use the library file in the seeed folder and move the conflicting library file out of the arduino library. Multiple libraries were found for "TFT_eSPI.h" Used : C : \ Users \ Dave \ Documents \ Arduino \ libraries \ TFT_eSPI - master Not used : C : \ Users \ Dave \ AppData \ Local \ Arduino15 \ packages \ Seeeduino \ hardware \ samd \ 1.8.2 \ libraries \ Seeed_Arduino_LCD When you upload the program, an error will occur and the compiler will prompt you that multiple library files are found. ![]() Library File Name Conflicts ¶Īfter you install seeed-arduinocore-samd, the core will download some library files to drive different devices at the same time, such as TFT_eSPI.h, etc. In addition to power-on and reset, when using SWD, Digital, Analog, Serial, I2C, there will be no interference, you can switch at any time, but in order to avoid possible problems, we still recommend removing this after completing the program debugging Connection of two pads. When powering on and resetting, you need to make sure that the Grove interface is not connected to any Grove module (the module may have pull-up / pull-down resistors, which will affect it), otherwise it will Enter SWD mode directly and cannot run in normal mode (that is, SWDCLK cannot be pulled low during power-on or reset) This will connect the SWD interface (SWDIO / SWCLK) of ATSMAD51 to Grove in parallel on the interface.Īfter our test, the SWD interface is connected in parallel in this way. You can connect these two pads by soldering a 0 ohm resistor or shorting it. The picture shows the two unmounted resistor positions. ![]() Powerful Wireless Connectivity (supported only by Arduino).SPI, I2C, I2S, ADC, DAC, PWM, UART(Serial).ARM Cortex-M4F core running at 120MHz(Boost up to 200MHz).MCU, LCD, WIFI, BT, IMU, Microphone, Speaker, microSD Card, Light Sensor, 5-Way Switch, Infrared Emitter (IR 940nm), Crypto-authentication Ready.Wio Terminal in Deep Learning supproted by CAVEDU Education Lesson 14 - Use Wio Terminal as a Keyboard for PC Lesson 13 - Use Wio Terminal as a Mouse for PC Lesson 12 - Smart Garden Project using Wio Terminal Lesson 11 - Build a TV Remote using the built-in IR Emitter Lesson 10 - Built-In Hardware/ Sensors Part 3 | Accelerometer
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |